Control Plane High Availability#

You can create high availability for the control plane by distributing the control plane across multiple nodes and installing a load balancer on top. Etcd can be colocated with the controller nodes (default in k0s) to achieve highly available datastore at the same time.

k0s high availability

Note: In this context even 2 node controlplane is considered HA even though it's not really HA from etcd point of view. The same requirement for LB still applies.

Network considerations#

You should plan to allocate the control plane nodes into different zones. This will avoid failures in case one zone fails.

For etcd high availability it's recommended to configure 3 or 5 controller nodes. For more information, refer to the etcd documentation.

Load Balancer#

Control plane high availability requires a tcp load balancer, which acts as a single point of contact to access the controllers. The load balancer needs to allow and route traffic to each controller through the following ports:

6443 (for Kubernetes API)
8132 (for Konnectivity)
9443 (for controller join API)

The load balancer can be implemented in many different ways and k0s doesn't have any additional requirements. You can use for example HAProxy, NGINX or your cloud provider's load balancer.

Example configuration: HAProxy#

Add the following lines to the end of the haproxy.cfg:

frontend kubeAPI
    bind :6443
    mode tcp
    default_backend kubeAPI_backend
frontend konnectivity
    bind :8132
    mode tcp
    default_backend konnectivity_backend
frontend controllerJoinAPI
    bind :9443
    mode tcp
    default_backend controllerJoinAPI_backend

backend kubeAPI_backend
    mode tcp
    server k0s-controller1 <ip-address1>:6443 check check-ssl verify none
    server k0s-controller2 <ip-address2>:6443 check check-ssl verify none
    server k0s-controller3 <ip-address3>:6443 check check-ssl verify none
backend konnectivity_backend
    mode tcp
    server k0s-controller1 <ip-address1>:8132 check check-ssl verify none
    server k0s-controller2 <ip-address2>:8132 check check-ssl verify none
    server k0s-controller3 <ip-address3>:8132 check check-ssl verify none
backend controllerJoinAPI_backend
    mode tcp
    server k0s-controller1 <ip-address1>:9443 check check-ssl verify none
    server k0s-controller2 <ip-address2>:9443 check check-ssl verify none
    server k0s-controller3 <ip-address3>:9443 check check-ssl verify none

listen stats
   bind *:9000
   mode http
   stats enable
   stats uri /

The last block "listen stats" is optional, but can be helpful. It enables HAProxy statistics with a separate dashboard to monitor for example the health of each backend server. You can access it using a web browser:

http://<ip-addr>:9000

Restart HAProxy to apply the configuration changes.

k0s configuration#

The load balancer address must be configured to k0s either by using k0s.yaml or by using k0sctl to automatically deploy all controllers with the same configuration:

Configuration using k0s.yaml (for each controller)#

Note to update your load balancer's public ip address into two places.

spec:
  api:
    externalAddress: <load balancer public ip address>
    sans:
    - <load balancer public ip address>

Configuration using k0sctl.yaml (for k0sctl)#

Add the following lines to the end of the k0sctl.yaml. Note to update your load balancer's public ip address into two places.

  k0s:
    config:
      spec:
        api:
          externalAddress: <load balancer public ip address>
          sans:
          - <load balancer public ip address>

For greater detail about k0s configuration, refer to the Full configuration file reference.